VIA TECHNOLOGIES

WE PROVIDE THE FULL COMPLEX OF SERVICES FOR DEVELOPMENT, RESTORATION AND MODERNIZATION OF A WIDE SPECTRUM OF MACHINES WITH THE MANAGEMENT OF DOMESTIC AND FOREIGN MANUFACTURE

Overhaul

The list of works produced on technological equipment with its full restoration:

By mechanic:

  • complete disassembly of process equipment and its components, checking the condition of parts;
  • restoration (replacement) of parts, assembly of technological equipment units, painting;
  • a full scope of tests of mechanics according to the specifications of this technological equipment;

By electrician:

  • thorough revision, repair and painting of the electrical cabinet, replacement of faulty electric appliances;
  • full or partial replacement of cable lines;
  • diagnostics of position sensors, replacement of unreliable sensors;
  • control and preventive maintenance on drive motors;
  • diagnostics, repair, replacement of boards, adjustment of drive units, testing of drives on the stand;
  • in the absence of drive units or the impossibility of their repair - replacement for the same or similar.

By electronics:

  • diagnostics of the measuring system, repair or replacement of sensors for the same or similar;
  • diagnostics of the state of the control system;
  • repair, replacement of sub-blocks, adjustment of sub-blocks, testing of the control system on the stand;
  • in the absence or impossibility of repair - replacement of the control system for the same or similar;
  • if necessary - making changes to the software.

On the technological equipment as a whole:

  • commissioning works on the machine;
  • a full range of tests on the specifications of this technological equipment;
  • support of manufacturing of a batch of parts;
  • training;
  • warranty service.

As a result of the restoration work the customer receives the technological equipment in the following condition:

  • The mechanical part of the process equipment corresponds to the accuracy standards according to the specifications for this machine;
  • the state of insulation of electrical circuits corresponds to PES;
  • transient resistance in contact points is minimal;
  • apparatuses and wires are marked;
  • reliable switching of electrical circuits by devices;
  • the protective equipment corresponds to the scheme and specifications;
  • non-contact sensors operate reliably;
  • electric motors are cleaned and dried;
  • the collectors are ground and grooved, the brushes are replaced;
  • drives are repaired, tuned and tested;
  • the measuring sensors are checked and exhibited;
  • the control unit is checked, tuned and tested;
  • the technological equipment is debugged, tested for reliability;
  • the technological equipment is checked according to the accuracy standards on the test parts;
  • a batch of customer's parts is made;
  • the staff is trained, the documentation has been transferred in full;

The consequence of this are:

  • full restoration of working capacity of the process equipment;
  • restoration of its technological capabilities;
  • restoration of the accuracy characteristics of technological equipment;
  • reduction of costs for cutting tools;
  • decrease in the percentage of defects;
  • reduced downtime;
  • increase the safety of personnel work.

CONTACT US

Kotlova st. 216, Kharkiv, 61145, Ukraine

+3 (097) 949 09 16

worktvs@gmail.com